junger d07 Operation Manual page 76

Under MAINTENACE -> SYSTEM CONFIGURATION you will be able to change the
device's network configuration according to the settings of the LAN you want to use.
After having changed the settings click CHANGE NETWORK CONFIGURATION and
after that REBOOT THE CONTROLLER (Maintenance -> Reboot Controller).
Rebooting the device activates the changes you have made to the network
configuration. If you changed the IP address of the device, you may not be able
to reach the web interface after the reboot.
Now you have to change the settings of your PC network configuration again and
connect both the PC and the device to the LAN you want to use. Then you will be able
to communicate with the device over web browser via the chosen IP-address.
2.
When you want to communicate with the device via Ethernet crossover cable you can
C
of the
OR
D
your device.
C)
you get to the
D)
match the
1.A
After having done the reset of the PC's
configuration you will be able to communicate with the device via
B 6 – Network Integration
Connection via Ethernet crossover cable
change your PC network settings and match them to those
device
keep your PC network settings and change the ones of
to change the PC network settings please refer to
modules web page. And you are done!
if you want to keep the PC network settings you can either
device's configuration via serial connection (see
) or you have to do
Ethernet crossover cable.
the procedure explained in
network
1.B.
Follow the instructions till
1.B
.