Main Drive Assembly - IBM Infoprint 1130 Service Manual

Hide thumbs Also See for Infoprint 1130:

Table of Contents

IBM Infoprint 1130/1140

Main Drive Assembly

1. Remove the inner EMC shield.

2. Remove the gear guard.

3. Remove the developer drive assembly.

4. Remove the transfer shaft (A) through the bottom of the printer.

5. Remove all cables from the cable clamps (B) on the main drive

6. Remove the ground cables (F). Be sure to reinstall the ground

cables to the same location.

7. Remove the main drive assembly mounting screws (C).

8. Remove the link (D) from the rear of the main drive assembly.

9. Disconnect the cable from the main drive motor.

Repair Information

Infoprint 1140