Table of Contents
Advertisement
IBM Infoprint 1130/1140
FRU
4
System Board HVPS
Connector
2-116
Service Manual
Action
Check the following voltages at J25
on the system board. Measure the
voltages from J25 to printer ground.
Printer Idle
J25-1 approximately 0 V dc
J25-2 approximately 4 V dc
J25-4 approximately 0 V dc
Printer Printing
J25-1 varies 0 V dc to +5 V dc
J25-2 varies 0 V dc to +4 V dc
J25-4 varies 0 V dc to +1.9 V dc
If J25-1 voltage is incorrect, check
the continuity of the front harness
cable (J25-1 line). If there is no
continuity, replace the harness
cable. If there is continuity, replace
the HVPS. If this does not correct
the problem, replace the system
board.
If J25-2 voltage is incorrect or if the
voltage remains at 0 V dc, check the
continuity of the front harness cable
(J25-2 line). If there is no continuity,
replace the harness cable. If there is
continuity, replace the HVPS. If this
does not correct the problem,
replace the system board.
If J25-4 voltage is incorrect, check
the front harness cable (J25-4 line).
If there is not continuity, replace the
harness cable. If correct, replace the
system board. if this does not correct
the problem, replace the HVPS.
Advertisement
Table of Contents
