Paper Jams - Options - IBM Infoprint 1130 Service Manual

Hide thumbs Also See for Infoprint 1130:
Table of Contents

Advertisement

IBM Infoprint 1130/1140
Error Message 202 - Paper Jam - Open Rear Door
This message indicates the paper is jammed at or near the printer
exit sensor located in the fuser assembly. This can be caused by the
paper arriving at the sensor too late, the paper jammed in the fuser
assembly or jammed exiting the fuser assembly in the redrive
assembly, or the exit sensor flag is not operating correctly. If an
output option is installed on the printer, a 202 paper jam may be
displayed if the option is not operating properly, especially the pass
thru sensor of the output option. Remove the output options from the
printer and check the printer for correct operation. If the printer
operates correctly, then install one output option at a time and check
which one fails.
Note: When the StapleSmart Finisher option is installed, a
secondary message may be displayed which advises whether or not
to remove the job from the finisher. If a job has accumulated in the
finisher, then the printer alternately flashes the primary and
secondary messages to indicate that all accumulated sheets should
not be removed during the jam clearance procedure. If the sheets
are removed, then the printer does not reprint these sheets.

Paper Jams - Options

Error Message 230 Paper Jam - Check Duplex Option
The paper is most likely jammed in the duplex unit, however the
paper can also be jammed in the redrive at the input to the duplex
option. The redrive assembly may not be correctly installed or
locked in position or the duplex link is bent and not aligned properly
to allow paper to feed correctly into the duplex option.
Note: When the StapleSmart Finisher is installed, a secondary
message may be displayed which advises whether or not to remove
the job from the finisher. If a job has accumulated in the finisher, then
the printer alternately flashes the primary and secondary messages
to indicate that all accumulated sheets should not be removed
during the jam clearance procedure. If the sheets are removed, then
the printer does not reprint these sheets.
Diagnostic Aids
3-41

Advertisement

Table of Contents
loading

This manual is also suitable for:

Infoprint 1140

Table of Contents