Table of Contents
Advertisement
IBM Infoprint 1130/1140
Operator Panel Cable/Cover Open Switch Assembly
Note: Pay careful attention to the cable routing through the printer
before you remove the operator panel cable/cover open switch
assembly.
1. Remove the left door and upper front cover.
2. Disconnect the operator panel/cover open switch cable from the
system board.
3. Cut the black cable tie that holds the operator panel/switch
cable and front harness.
4. Remove the operator panel. Pull the cables through the
rectangular hole in the hinge pivot arm.
5. Plug the new operator panel cable into the operator panel and
snap the new cover open switch cable into the bracket
assembly.
6. Route the cables and toroid through the rectangular window in
the cover hinge pivot arm.
7. Snap the operator panel into the upper front cover.
8. Be sure the toroid is on the opposite end of the cables near the
system board connectors.
9. Route the cables through the printer and down the inside of the
system board shield.
10.Plug the cables into the system board connectors.
Repair Information
4-49
Advertisement
Table of Contents
