Table of Contents
Advertisement
IBM Infoprint 1130/1140
Finisher Tests, StapleSmart Finisher Option
Feed Tests
This test feeds eight blank sheets of paper through the finisher
option and staples them.
Note: No buttons are active during this test and the test cannot be
terminated until it is complete.
To run this test:
1. Go to Diagnostic menu.
2. Select Finisher Tests from the Diagnostic menu.
3. Select Feed Tests from the menu.
Sensor Tests
This test consists of four menus which tests all the sensors in the
finisher option.
To run this test:
1. Go to the Diagnostic menu.
2. Select Finisher Tests from the Diagnostic menu.
3. Select one of the following menus.
To test the Staple Sensors:
Select Sensor Tests from the Finisher menu.
Select Staple Sensor Test from the Sensor Tests menu.
The following screen is displayed and each sensor can be checked
by actuating this flag.
Staple
SL=CL SP=CL H=CL
C=Cartridge Present Sensor
SL=Staple Low Sensor
SP=Self Priming Sensor
H=Home Signal Sensor
3-24
Service Manual
C=CL
Advertisement
Table of Contents
