Table of Contents
Advertisement
IBM Infoprint 1130/1140
The messages in the following table can occur in two ways. The
specified device could have been removed from the printer, for
instance to clear a paper jam. Otherwise, the device can still be
attached to the printer, but is experiencing a communications
problem, not fully connected, or having a hardware failure.
•
If the device is temporarily removed or not connected properly,
then reattach it. When the option is recognized, the printer
automatically clears the error and continues.
•
If the option is experiencing a hardware problem, turn the
printer off and back on. If the error occurs again, turn the printer
off, remove the option and call for service.
User Status Message
Turn Printer OFF to
Enable Option
Insert Duplex Front
Cover
Close Duplex Rear Door
2-40
Service Manual
Explanation
This message displays when a printer option,
Input Tray, Output Bin or Envelope Feeder, has
been attached while the printer is powered On. To
use the option, the printer must first be powered
off and back on again. Data loss results if print
jobs are active when the printer is power cycled. If
a print job is active, then remove the option and
finish the job. The printer automatically clears the
message once the option is removed. Once the
job is complete, turn off the printer and attach the
option again.
This message displays when the duplex front
access cover is not installed.
This message displays when the duplex rear door
is open.
Advertisement
Table of Contents
