Table of Contents
Advertisement
IBM Infoprint 1130/1140
No indication that Bin X is full OR No indication that Bin X is near
full
FRU
1
Dual Output Bin X Sensor
Assembly
Control Board
High-Capacity Output Stacker Service Check
Service Tip: The majority of the mechanical components can be
observed during operation by removing the left, right and front
covers. The high capacity output stacker option functions without the
covers installed.
Determine which paper path stacker assembly is not functioning
properly.
Make sure the option(s) are installed correctly and the machine is
configured correctly before attempting to service the high-capacity
output stacker option.
Go to
"High-Capacity Output Stacker Board" on page 5-14
identify the correct jumper location at J6 for the upper and lower
units.
2-96
Service Manual
Action
Check for correct installation of
the sensor cable at J5 on the
control board. If either the Bin Full
(F) or Bin Near Full (NF) fail the
sensor test then check the voltage
at J5-3 and J5-4. The voltage
measures approximately +5 V dc.
If the voltage is incorrect, replace
the control board. If correct,
replace the sensor assembly.
to
Advertisement
Table of Contents
