Table of Contents
Advertisement
June 13, 2008 Final Draft
Installing the thermal printhead assembly
Follow these procedures to install the thermal printhead assembly:
1. Open the paper door by pressing the blue release button (see Figure 9 on page
Figure 11. Installing the thermal printhead assembly
2. See 1 in Figure 11. Open the paper-out sensor by grasping the edge and
3. As shown in 2 , press downward on the thermal printhead assembly.
4. Lift the printhead assembly outward to remove (see 3 ).
Attention
Printer should be powered off. The following ESD handling procedure is
recommended: You should touch the metal on the printer frame with the back
of your hand before allowing the printhead to make contact with the printer.
Also, see "Electrostatic Discharge (ESD)" on page 46.
13).
1
pulling downward.
DRAFT
Installing 4610 Models 2CR and 2NR
2
Chapter 2. Installing the 4610 Models 2CR and 2NR
3
15
Advertisement
Table of Contents
