Table of Contents
Advertisement
IBM Infoprint 1130/1140
Envelope Feeder (if installed)
For each input source selected you have the following choices:
•
Single (prints the Print Test Page once)
•
Continuous (continue printing the Print Test Page until Return or
Stop is pressed).
The contents of the Print Test Page varies depending on the media
installed in the selected input source.
Note: The Print Test Page always prints on one side of the paper,
regardless of the duplex setting or the presence of a duplex option.
If a source is selected that contains envelopes, an envelope test
pattern is printed. If Continuous is selected, the test pattern is
printed only on the first envelope.
To run the Print Test Page:
1. Select Print Tests from the Diagnostic menu.
2. Select the media source.
3. Select Single or Continuous.
– If Single is selected no buttons are active during printing.
– If Continuous is selected, Return or Stop can be selected to
cancel the test.
Check each Test Page from each source to assist in Print Quality
and Paper Feed problems.
Print Quality Test Pages
The purpose of this diagnostic function is to allow printing of the print
quality test pages with the toner cartridge lockout function disabled.
The print quality test consists of three pages. Page one contains a
mixture of graphics and text. Pages two and three only contain
graphics. If duplex is turned On, the pages are duplexed, otherwise
the pages are printed on one side. The Print Quality Test pages are
printed in English and must always be printed on letter, legal or A4
paper.
Note: The print quality test pages can also be printed from the
Configuration menu, however a cartridge must be installed with a
3-34
Service Manual
Advertisement
Table of Contents
