General Performance Specifications; Print Quality And Registration Specifications; Job Setup; Maximum Percentage Of Coverage - IBM InfoPrint Color 100 Introduction And Planning Manual

Note: The InfoPrint Color 100 printer is shipped with Ethernet or Token Ring. To help prevent installation
delays, have someone familiar with your LAN configuration available to assist the systems engineer
and service representative during the InfoPrint Color 100 installation.
See "Network Protocols" on page 33 for information about supported protocols.
The IBM InfoPrint Color 100: Maintenance Library contains configuration information.
Service Interface
The service representative uses the same GUI interface as the operator, to service the printer. The service
representative also uses the interface to run several diagnostic aids.
The IBM InfoPrint Color 100: Maintenance Library , describes the diagnostics package and the operator
console's service mode capabilities.
General Performance Specifications
This section lists the general performance specifications of the InfoPrint Color 100.
Process speed
Letter-size sheets per minute
Letter-size impressions per minute
Dot density
Printed line width (maximum)
Paper width (maximum)
Paper width (minimum)
Paper length as cut
Paper roll diameter
Paper input capacity
Jogger capacity
Stacked paper sizes (length)
Manual splicing station
* Other throughputs can be calculated using the web speed.
** Maximum that printhead can print. See "Print Area" on page 7 for more information.
*** Longer lengths will require operator assistance.
Print Quality and Registration Specifications
The following print specifications apply when the operating environment is within optimum operating
ranges. (See "Environmental Requirements" on page 9 and "Paper" on page 30.)

Job Setup

You may need to print 25 or more impressions to adjust registration and density.

Maximum Percentage of Coverage

It is expected that a typical job will have 17% toner coverage for each color. Print quality may degrade
during long runs of over 100 impressions per side if the toner coverage exceeds 70% per color. It may be
6
IBM InfoPrint Color 100 Introduction and Planning Guide
12.25 cm (4.82 in.) per second
52 simplex or duplex*
52 simplex or 105 duplex*
600 x 600 dpi
475 mm (18.70 in.) centered on paper**
508 mm (20.04 in.)
500 mm (19.96 in.)
150 - 11 097 mm (5.9 - 436.9 in.)
500 mm (19.7 in.) maximum
264 lb roll (standard)
100 mm (3.9 in.) (maximum height)
50 kg (maximum weight)
150 mm - 1 000 mm (5.91 - 39.37 in.)***
Standard feature