Transferring The Ups To Bypass Mode; Operating Modes - Avaya RS9RM Preparation, Installation And Operator Manual

Transferring the UPS to Bypass Mode

NOTE When the UPS is in Bypass mode, Battery mode is not available and the UPS does
not protect against power outages; however, the utility power continues to be passively
filtered by the UPS.
Press the On button for approximately eight seconds to transfer the
UPS to Bypass mode. The
Press the On button again for approximately three seconds to return to
Normal mode.

Operating Modes

Avaya RS9RM's front panel indicates the UPS status through the UPS
indicators. Figure 12 shows the UPS front panel indicators and controls.
Normal Mode Indicator
Battery Mode Indicator
Bypass Mode Indicator
Test/Alarm Reset Button
Avaya RS9RM 6000 VA Hardwired UPS Site Preparation, Installation and Operator's Manual
indicator illuminates.
Off Button On Button
Figure 12. UPS Front Panel
OPERATION
Alarm Indicators (see page 47)
Bar Graph Indicators
Indicator Legend
Unlit
Lit
Flashing
S
164201528 Rev C
31