Electrical Requirements - Kenmore 110.2810 Series Installation Instructions Manual

ELECTRICAL REQUIREMENTS

A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical
■
supply is required. A time-delay fuse or circuit breaker on a
separate circuit serving only this washer is recommended.
This washer is equipped with a power supply cord having a
■
3-prong grounding plug.
To minimize possible shock hazard, the cord must be plugged
■
into a mating, 3-prong, grounding-type outlet, grounded in
accordance with local codes and ordinances. If a mating outlet
is not available, it is the personal responsibility and obligation
of the customer to have the properly grounded outlet installed
by a qualified electrician.
If codes permit and a separate ground wire is used, it is
■
recommended that a qualified electrician determine that the
ground path is adequate.
Do not ground to a gas pipe.
■
Check with a qualified electrician if you are not sure the
■
washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
■
6