Routes; Creating A Route Using Waypoints; Changing Name To A Route - Standard Horizon CPF180i Owner's Manual

9.

ROUTES

The CPF180i and the CPF300i have the capability to store 50 Routes with 100 Waypoints
or Marks in each Route. A Route can consist of Waypoints or Marks. The difference is when
a Route is made using Waypoints and the Route is deleted the Waypoints are also deleted.
However if a Route is made of Marks and the Route is deleted the Marks stay in memory.
9.0

CREATING A ROUTE USING WAYPOINTS

1. On the Chart page move the ShuttlePoint knob to the Lat/Lon of the starting Waypoint
in the Route.
2. Press [ROUTE], you will notice the Starting Waypoint
cursor.
3. Move the ShuttlePoint knob to the second Lat/Lon of the next leg
4. Press [ROUTE]. You will notice another Waypoint is shown under the cursor and a line
joins the starting Waypoint to the Second Waypoint.
5. Repeat steps 3 and 4 until all Waypoints are entered into the Route.
At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific
name follow the next steps.
9.1

CHANGING NAME TO A ROUTE

To name the Route:
1. Press [MENU]. Move the ShuttlePoint knob to highlight USER POINTS and press
[ENT].
2. Move the ShuttlePoint knob to highlight ROUTE and press [ENT].
3. Move the ShuttlePoint knob to highlight REPORT and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight NAME and press [ENT]. A popup window will
be shown.
5. Move the ShuttlePoint knob up/down to change the characters and left/right to select
a different character in the Routes Name.
CPF180i and CPF300i
Figure 9.0 - Creating a Route using Waypoints
NOTE
will be placed under the
in the Route.
Page 71
R