Hydraulic System - KBC BAH-1010AVS Instruction Manual

~.
~
. - . .
,
.
'2
. . .
I
..,.
,
.
.~
~
~.
AYDRAULIC SYSTEM
SECTION
5
HYDRAULIC SYSTEM
5.1 INTRODUCTION
The hydraulic system used in this semi-automatic bandsaw
is
very simple since the hydraulic
force is used to lift the sawhead only. M e r rising to the top position, the sawhead
can
be held by
turning the downfeed rate control dial to zero. By the way, the descending speed of the sawhead is
also controlled by this flow control valve. In addition, a solenoid valve is used to control the
moving direction of the lifting cylinder.
All of the hydraulic units are installed
in
the base cabinet so that the noise of the hydraulic
units (i.e. hydraulic motor and pump) is isolated and then the machine performs quietly.
The hydraulic circuit of this system is shown
in section 5.2 while the hydraulic layout is
shown in section 5.3, both of them can help while considering the motion sequence of this machine.
Please refer tothe hydraulic circuit and layout and disconnect all the powers before doing
maintenance. COSEN or the local agent will supply the hydraulic components if needed.