KBC BAH-1010AVS Instruction Manual page 39

I
OPERATING INSTRUCTION
-
Section
3
NOTE:
Counter and the reset button functions in both "manual" and "automatic" mode, and only
-
with the lid for preset interface closed.
The red dial in the reset button locks and unlocks the reset button.
Counter functions by counting the number of times saw bow reaches the lower limit switch.
When the counter reaches the preset value, the machine will shut off. In order to restarf one
must reset the count readout.
PRESET readout(yel1ow color digital number):
Indicates the number of pieces to be cut in the automatic mode. The setup range is 1 to
99999.
You can tumlrotate the number dial for count changing anytime during the cutting operation
.
Please close the lid after the target cuts number has been set.
2.
POWER indicator lamp
Indicates that the power of band saw machine is tumed on. Light comes on when you turn on machine
circuit breaker switch on the electrical enclosure for machine. This lamp indicates preparation for start-
UP.
3.
AUTOlMANUAL select switch
Use to select automatic or manual mode of operation. When the switch is turned to MANUAL@),
you can operate each function individually. When the switch is turned to AUTO(=), the machine
-
automatically operates according to the preset cutting data.
u
When the machine is first started in the MANUAL mode and then switched to the AUTO mode, the
first cut is not counted, but the machine automatically operates according to the preset cutting data
This function can
be used for the machine to automatically cut the work after it trims the end of the
work.
u
In the automatic mode, when the switch is turned to MANUAL during cutting, the machine stops on
completion of the cut, and when the switch is turned to W A L during the operation other than
cutting, the machine stops immediately.
4.
MOTION DETECTOR ONJOFF safety switch
Motion detector can automatically detect and shut down the machine for improper blade tension or
blade breakage. The safety switch must be turned on before operating the machine. When changing
the blade, the power should be off and safety switch should be turned on to prevent accidental start.
NOTE: Saw blade must be tensioned to operate machine. Please see Sec 4.3.3 for detail.
When safety switch is on, machine will not start: -
-
without saw blade mounted.
-
should saw blade not be correctly tensioned.
-
after blade breakage.
The machine can be operated in "OFF" position, however, the motion detector then is
disengaged. We recommend you keep the safety switch "ON" at all times.
5.
MANUAL FORWARD/BACKWARD STOCK FEED select switch
Select feeding "forward," "off' or "backward" by turning the dial to left, center, or right position.