Table of Contents
Advertisement
OPERATING INSTRUCTION
Seaion 3
Determine the proper cutting position of the workpiece using the following procedures:'
1. Clamp the material with the hand wheel, and raise the saw bow until it reaches the highest position.
-
2. log the stock to desired cutting length with control (5
)
or vise motor for micro adjustments.
3. Then lower the saw bow carefklly to the position that the clearance between the saw blade teeth
edge and the material top point is about
5 mm.
4.
Turn
OFF the machine
as
well as power to adjust anything manually.
5. Install the cutting lengthpreset device for convenient length setting for cutting more than one
piece.
Once you turn the machine back on, you are ready to perform cutting. For cutting, please follow the
instructions stated in Sec 3.6
-If the work cannot be securely clamped with the roller vises, use the Vertical Clamping Roller to
clamp it securely. It is dangerous if the work is clamped loosely and forced out of the vises during
cutting.
3.6 TEST RUN
THE MACHINE
By following the procedures and operating properly, your machine will be performing excellently for
the days to come.
3.6.1 Manual Mode
It might be necessary to use the machine for single cuts without automatic feeding. First of all, the
selector switch (3) must be set to "manual" position.
Stock Feeding: The stock can either be fed against the material stop with manual stock feed selector
(6) or adjusted to length by manually rotate the handwheel mounted coaxial with the feed motor.
Saw Bow Movement: In manual mode, saw bow stays down after each cut. Lifting or down feed of
saw bow must be activated by manually depress the push button respectively (9) and (10). When saw
bow down feeds, the rate is controlled by the Flow Control Valve on the right guide arm which can be
-
easily adjusted &om the Downfeed Rate Control Dial (12) on the control panel. If one needs to keep
saw
bow
at lifting position, simply let go of saw bow movement controls. It will stay right where you
leave it.
Hide quick links:
Advertisement
Table of Contents
