KBC BAH-1010AVS Instruction Manual page 45

1
OPERATING INSTRUCTION
-
Section 3
3. Blade tension should be adjusted so that the blade will not slip on the bandwheels during the
cutting period. Do not apply excessive tension to the blade to prevent breaking.
-
NOTE:
As
you turn the saw blade tension handle clockwise until bottom of handle meets the stopper,
line up the two grooves. (This level of tension is factory adjusted.)
I
BLADE mSIONHANDLE LEVE
\
1. Turn on the machine, and operate under "Manual Mode."
2. Properly load the work piece. (Please see Sec 3.5 "How to Load the Work Piece")
3. Clamp the material with the hand wheel, and raise the saw bow until it reaches the highest position.
4. Jog the stock to desired cutting length with control (5) and or vise motor for micro adjustments.
5. Then lower the saw bow carefully to the position that the clearance between the saw blade teeth
-
edge and the material top point is about 5 mm.
6. Turn OFF the machine as well as power.
7. Unpack the depth bars (3-34). (Please see Parts Diagram 3: Bed) Insert them in the holes on the
front and rear sides of the bed, slightly below the guiding anns. Push in bars until they are flush
with the rear side of machine bed, fasten setscrews at the rear end.
8. Assembly the right adapter(3-35) and lefi adapter (3-39) with one fastening bolt each.
9. Then install the cross slide (3-40) and the preset length stopper (factory assembled) accordingly.
10. Now push preset length stopper onto the material along the bars, the pin of the device should
touch the material at its upper utmost right hand side to ensure that the sawn off piece can fall -
down freely. Also be sure that all clamping wheels and levers of the stop mechanism are clamped
tightly.
11. The guide arms or guides must never touch the stock but should be set as close as possible to the
-
stock to be sawn. Be
sure
that the guide arms are clamped tightly to the dovetail guide with the
help of the clamping handle.
12. The upper end limit switch can be adjusted in accordance of stock's height. The adjustment of this
switch should guarantee that the up-movement of the saw bow is stopped just above the material.