KBC BAH-1010AVS Instruction Manual page 40

-
I
OPERATING INSTRUCTION
-
Sedion 3
6.
BLADE DRIVE ONJOFF button (with light)
ON mode(green color button):
-
Press to start the saw blade motor.
w
The saw blade begins to drive only when the clamp has secured the workpiece.
OFF mode(red color button):
Press to stop the saw blade motor.
7.
MACHINE ON buttons
ON mode(green color button):
Press to enable the machine for operation.
-
This button is disabled when the EMERGENCY STOP (4)
is pressed.
8.
EMERGENCY STOP button
Press to stop the machine in an emergency. When you press it, it brings the machine to a total stop.
The button locks when pressed and must be turned to unlocked it.
-
9.
SAW BOW UP MOVEMENT button
In manual and automatic mode, saw bow will raise to the highest position when this button is
-
depressed.
10.
SAW BOW DOWN MOVEMENT button
In manual mode, this control will enable the saw bow to move downward till reaching the lowest
position as long as it's depressed. In automatic mode, this button does not interrupt the pre-
-
programmed actions.
1 1.
COOLANT SUPPLY select switch
This select switch is used to control the coolant supplying to the cutting area.
"I" mode:
If the select switch is turned to this mode, the coolant will be supplied to the cutting area
"W
mode:
If the select switch is turned to this mode, the coolant will not be supplied.
ATTENTION: The lower part of the base serves
as
coolant tank.
The cutting fluid is supplied to the saw guides and should be mixed in accordance
-
with the recommendations of the supplier. It should not contain too much grease to
avoid slipping of the saw blade on the wheel.
Never work with pure water only.
To clean the tank, please take off the discharge table and steel sheet cover.
12.
DOWNFEED RATE CONTROL dial
This control dial is used to control the downfeed rate of the saw blade during the cutting period. Turn
the dial counterclockwise to increase the down feed rate and decrease the cutting time; turn the dial
clockwise to decrease the downfeed rate and increase the cutting time.