KBC BAH-1010AVS Instruction Manual page 32

1 I
MOVING AND INSTALLATION
I
w;.X-..X--" \&\8-.".~we<m"y,.y.*~" :<
, * ~ 3 , < c ~ . 7 ~ ~ ~ > ~ < . , <
.,*,xv. ".*y~"+v*"...
Section 2
& &
, ,
3 , :
. . , . . . ,
: ?
3 $ i ? ~ : .
< *
j '
' ' ' $ < y ~ ~ *
,:+.%%?A.
.;~>.:..,>3z&$*;>>*st*:;*;~.~."A,+~~:?<~~*.~,*:~*~.~*,.:
Fm"*,:a,*
**-*
*
<*w,m,m
- ; . .
.. . A,,"<.:vx
>, . *
%..2%.*?
+
A,.>
~
, a f i . 3 ! 2
:s>
: ~
. -.
Place spirit levels on the vise slide plates and the work feed table, and adjust the left-and-
right A d fore-and-aft level of the machine with leveling bolts.
-
The fore-and-aft level should be adjusted rightly. The level of the rear for the machine is
approximately 25 mm(1 in.) higher than the level of the front end. This will allow the proper
return of the cutting fluid for working. The illustration as show as Following:
u
Be sure to ascertain that all leveling bolts evenly support the weight of the machine.
*
Use a level gage to make sure that the platform is
flat and even at all angle.
If you plan to cut long workplaces, please arrange the roller table and roller stand behind the
machine.
-The roller table and roller stand should be level with the machine itself.