Procedures To Stop An Operating Process - KBC BAH-1010AVS Instruction Manual

.
%
.
. " . . ~
..:,
,
.
,
-~
.
. > .
, .
~. ~ . .
I
.
,.
.
.
--
~
OPERATING INSTRUCTION
SeEtion 3
3 . 8
PROCEDURES TO STOP AN OPERATING PROCESS
.
: :
Manual and Automatic Cutting Operation:
To stop the cutting operation, please press the BLADE STOP button, MACHINE OFF button,
EMERGENCY STOP, or POWER OFF switch on the electrical cabinet.
The saw blade doesn't stop running when the BLADE UP button is pressed. You must press
BLADE STOP
afterwards. If this
is not an emergency, we recommend you raise the blade first
before you stop the blade to protect the blade from clogging inside the stock. If you press the
MACHlNE OFF button, both the saw blade and hydraulic pump motor will stop
running.
When an error occurs, the machine automatically stops, please refer to section 10 for
troubleshooting.
Resuming Automatic Operation:
-
When the above buttons (BLADE STOP button, MACHINE OFF button, EMERGENCY STOP,
or POWER OFF switch) are pressed in the middle of a cutting operation, the pieces being cut will
not be counted among the number of pieces already cut.
The operation stopped by pressing any of the above buttons can be resumed by pressing the
BLADE DRIVE button after the machine is turned back on. Unkss the
Curring Piece Counter
has
been reset to zero, the stock not properly clamped, or an error occurs.
When the AUTOIMANUAL select switch is turned to MANUAL while the machine is operating
in
the automatic mode, the machine keeps on cutting until it reaches the lower limit switch
position.