KBC BAH-1010AVS Instruction Manual page 55

I
OPERATING INSTRUCTION
Se&on
3
9. Install the saw blade on the drive and driven wheels with the cutting edge facing down.
10. Put the saw blade into the left-hand and right-hand saw blade inserts until the back of the blade is
slightly touching the backup rollers (thrust rollers) in each saw blade insert.
11. Press the back of the saw blade against the flange of the drive wheel.
12. Press the back of the saw blade against the flange of the driven wheel, and turn the saw blade
tension handle clockwise until bottom of handle meets the stopper, then l i e up the two grooves.
(This level of tension is factory adjusted.)
13. Please gently close the wheel cover.
14. Reconnect the power to the machine, and turn the machine back on.
15. Press the blade drive "ON" button to start the saw blade
tunning
for a few seconds, then stop the
blade by pressing blade drive "OFF."
16.
Open the wheel cover and check to see that the saw blade is not off the drive and driven wheels
and is correctly located in the blade guides. (see Sec 3.3.3 for adjustment procedures).
17. Check and adjust if the brush is allowing the brush tips running free through the bottom of the
teeth.
18. Please close the wheel cover.
19. Your saw blade installation is complete.
Thank you for following the instructions. If there is any advice or comments, please send the "Return
Envelop" on the back of this manual along with feedback form to
us.
Your suggestions w i l l help us
understand and meet your needs.