Brother DCP-8085DN Service Manual page 477

Laser fax/mfc
Hide thumbs Also See for DCP-8085DN:
Table of Contents

Advertisement

• Selector 1: ECP mode
The ECP mode enhances the normal bidirectional communications between the machine
and the connected PC for higher transmission speed throgh the parallel interface.
• Selector 2: Recovery from Inactive PC Interface
If the machine recognizes via the STB signal line that the connected PC is powered off
throgh the parallel interface, it will turn the PC interface outputs Low to protect the PC from
hazards that could be caused by weak electric current accidentally flown from the machine.
This selector determines whether or not the machine should recover from the inactive PC
interface to normal interfacing state upon receipt of data from the PC.
• Selector 3: PC Power-off Recognition Time
This selector sets the time length from when the machine detects the PC powered off until
it recognizes the detected state as power-off.
If selector 2 is set to "0," it is recommended that selector 3 be set to "1"; otherwise, the
machine may mistakenly detect PC powered off.
• Selector 5: Escape from phase C
This selector determines whether or not the machine will escape from phase C when it
detects an RTC (Return to Control) in non-ECM mode or an RCP (Return to Control Partial
page) in ECM mode.
• Selectors 6 through 8: Extension of incoming calling signal (CI) frequency band
At the start of reception, if the machine detects the frequency of a CI signal specified by
selectors 1 through 4 on WSW14, it starts the ringer sounding. However, the machine may
fail to detect the CI signal normally due to noise superimposed at the time of reception. To
prevent it, use selectors 6 through 8 on WSW36.
If the machine detects higher frequencies than the setting made here, it regards them as
noise and interprets the detecting state as being normal, allowing the ringer to keep
sounding according to the preset number of ringers (until it starts automatic reception of
FAX data in the FAX mode or enters the TAD mode in the TEL mode).
specified by selectors 1 through 4 on WSW14
App. 1-43
Confidential

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mfc-8480dnMfc-8880dnMfc-8890dwDcp-8080dn

Table of Contents