Brother DCP-8085DN Service Manual page 285

(2) Lift up the CCD Module and Guide shaft and pull the Guide shaft out of the CCD Module.
Guide shaft
(3) Remove the Belt support rubber, and then remove the Belt from the CCD module.
(4) Remove the double-faced adhesive tape which is attached between the FFC cable and
CCD module, and disconnect the FFC cable from the CCD module.
Note:
• After disconnecting flat cable(s), check that each cable is not damaged at its end or
short-circuited.
• When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cables are not at an angle.
Belt support rubber
3a
3b
2b
2a
Fig. 5-101
Belt
Belt
Fig. 5-102
5-85
CCD Module
Scanner base
CCD module
FFC cable
Confidential