Operating In Battery Mode; Turning Inverter Operation On And Off - Xantrex Freedom X 2000 Owner's Manual

Operating in Battery Mode

The Freedom X is in Battery Mode (also called Inverter Mode)
when all the following conditions exist:
inverter power button is ON
n
ignition auto-on is activated
shore power is not presently available
n
battery has sufficient power
n
Inverter operation means that DC battery power is presently being
converted to utility grade AC power, powering equipment and
appliances connected to the AC output terminal of the unit. The
green status LED lights up to indicate the Freedom X is using the
battery to power the equipment and appliances.
BATT.MODE
975-0822-01-01
(down position) or

Turning Inverter Operation ON and OFF

There are two ways to operate the Freedom X's inverter function.
1. Press the Power button to a down position (it is in Standby in
the up position).
2. When the inverter's Ignition Control feature is set to Auto-on
a
(ATO) , a +12VDC signal is present on the ACC input
ELECTRICAL SHOCK HAZARD
Turning the Power k button to Standby does not disconnect DC
battery power from the Freedom X. You must disconnect from all
power sources before working on any circuits connected to the unit.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
To prevent unnecessary battery discharge, press the Power
button to Standby when you are not using the Freedom X.
a
See Adjusting Settings in Configuration Mode on page 47.
b
When the vehicle's ignition switch is On or the vehicle's engine is running.

Operating in Battery Mode

WARNING
b
.
51