Automatic Scan; Satellite Scan - TechniSat EUROKLASSIK 1 Short Instructions

1. Automatic Scan

Select this type of search to scan all the satellites set in the menu Antenna settings (Point
6.4 and 10.4) for Programmes.

2. Satellite Scan

Select this type of search to scan only a specific selected satellite for Programmes.
3. Transponder Scan
Select this type of search to scan a specific transponder of a single satellite for Programmes.
4. Manual Scan
Select this type of search to search specifically for one particular programme, using the
programme-specific PID numbers.
When the search has been completed, a message will appear on screen indicating how
many programmes your digital receiver has found, how many of these are new programmes,
and how many are encrypted Programmes. New programmes are saved in the Total list,
and can then be transferred to the Favourites list in accordance with Point 9.1
> To commence searching for programmes, first call up the Main menu.
> Use the arrow keys up/down to mark the line Scan channels.
> Confirm by pressing OK.
The sub-menu Scan channels will be displayed.
> Now use the arrow keys up/down to select the type of scan you wish to perform,
and confirm by pressing OK.
9.4.1 Automatic scan
If this scan is selected, all the satellites listed in the menu Antenna settings (Point 6.4 and
10.4) will be scanned automatically for Programmes. You can decide whether you wish to
scan for all programmes (free-to-air and encrypted) or only for free-to-air Programmes.
> By pressing the OK key, decide whether you wish to scan only for free-to-air
programmes (Free programmes), or whether you wish to include encrypted
programmes in the search (All programmes).
> Use the arrow keys up/down to mark the field Start search, and confirm by
pressing OK.
Depending on the configuration of your antenna installation, a scan can take 15 minutes
or more. Please also note Points 9.4.5 and 9.4.6 and the on-screen messages
9.4.2 Satellite scan
To scan a single satellite for programmes, select Satellite scan. Here you can decide
whether you wish to scan for all (free-to-air and encrypted) programmes or only for free-to-air
Programmes.
> Press the OK key again to open the selection table for the active satellites selected in
accordance with Points 6.4 and 10.4.
> Use the arrow keys up/down to mark the menu item All satellites, to scan all
active satellites for programmes, or mark the desired satellite to scan only this
satellite for Programmes.
> Confirm by pressing OK.
72