INSTRUCTION MANUAL FOR THE TECHNISAT VC 2002 S n the interests of safety please read and observe the following instructions before using your new VC 2002 S. This sheet and the following pages concerning installation and operation should be retained for future reference.
TechniSat ® VC 2002 S APPLIANCE DESCRIPTION: FRONT PANEL STAND BY TechniSat VC 2002 S Digital Display STANDBY LED Decoder Card Slot AUTHORIZE BUTTON * Channel Up/Down Keys Press this button if you wish to see a “Pay per View” programme.
V/H POLARISATION DECODER (NORMAL/DECODER MODE) DECODER SIGNAL SELECTION (D1-D4) INSTALLATION & INITIAL OPERATION 1. Connect the receiver VC 2002 S to the LNB of the outdoor unit using a coaxial cable via IF-IN connection. CAUTION: Always ensure that the mains supply is off when making any connections (including LNB connection).
Page 6
TechniSat ® VC 2002 S Installation possibilities: 1) Connection to TV (+ external decoder if required) Receiver EUROSCART FOR VCR/REC EURO SCART FOR TV DECODER VIDEO SCART 2) Connection to TV + VCR Receiver EUROSCART FOR VCR/REC EURO SCART FOR TV...
“Individu- al Programming” (see below). i) Using V/H LNB: The TechniSat VC 2002 S is preprogrammed in accordance with programme table 1 at the end of this manual.
TechniSat ® VC 2002 S PROGRAMMING Watching a scrambled Videocrypt programme 1. Select a coded channel (eg. Movie Channel or Sky Movies Plus). 2. Insert the viewing card as indicated by the arrow. 3. After a few seconds the descrambled picture will appear on the screen.
Remote control does not operate or has poor range. CAUSE/SOLUTION 1. No power. Make certain that your VC 2002 S is connected to an appropriate AC power supply. 2. Power switch is off. Press power button. 3. Fuse has blown. Replace.