Switching On And Off; Channel Selectios - TechniSat EUROKLASSIK 1 Short Instructions

DiSEqC
> If you have DiSEqC components in your receiving installation, highlight the field Activate and confirm by
pressing OK
Position A/Option A
> Use the arrow keys up/down to highlight the satellite you wish to receive at the DiSEqC setting Position
A/Option A and confirm by pressing OK.
Position B/Option A
> Use the arrow keys up/down to highlight the satellite you wish to receive at the DiSEqC setting Position
B/Option A and confirm by pressing OK.
Position A/Option B
> Use the arrow keys up/down to highlight the satellite you wish to receive at the DiSEqC setting Position
A/Option B and confirm by pressing OK.
Position B/Option B
> Use the arrow keys up/down to highlight the satellite you wish to receive at the DiSEqC setting Position
B/Option B and confirm by pressing OK. In the next step, you should check on the correct configuration
of your antenna.
> If you wish to accept the settings entered, use the arrow keys up/down to highlight the field Yes, and
confirm by pressing OK.
Position A/Option B
> Use the arrow keys up/down to highlight the satellite you wish to receive at the DiSEqC setting Position
A/Option B and confirm by pressing OK.
Position B/Option B
> Use the arrow keys up/down to highlight the satellite you wish to receive at the DiSEqC setting Position
B/Option B and confirm by pressing OK. In the next step, you should check on the correct configuration
of your antenna.
> If you wish to accept the settings entered, use the arrow keys up/down to highlight the field Yes, and
confirm by pressing OK.
You can abort the initial installation at any time simply by pressing the red function key. Press the green
function key to go back to the previous step in the installation procedure. Thus any entries made incor-
rectly can be quickly corrected. If you do not implement the initial installation, or if it is not completed, the
receiver will commence operation with a standard pre-channeld configuration.
For daily use

Switching on and off

> Press the On/Standby key either on the digital receiver or the remote control to switch the receiver on.
> Press the same key again to switch the receiver off.
Channel selection
Using the channel up/down keys
> Use the channel up/down keys on the remote control or on the receiver to move up or down the list one
channel slot at a time.
6