Mitsubishi Electric FR-E500 Instruction Manual page 207

(3) Single-phase 100V power supply
Type FR-E510W-
Applicable motor capacity
(Note 1)
Rated capacity (kVA) (Note 2)
Rated output current (A)
Overload capacity
Rated output voltage (Note 4)
Rated input AC voltage,
frequency
Permissible AC voltage
fluctuation
Permissible frequency
fluctuation
Power supply capacity (kVA)
(Note 5)
Protective structure (JEM1030)
Cooling system
Approximate weight (kg(Ibs))
Note: 1. The applicable motor capacity indicated is the maximum capacity applicable
when a Mitsubishi 4-pole standard motor is used.
Normally, the rated current (at 50Hz) of the motor applied should not exceed
the rated current.
2. The rated output capacity indicated assumes that the output voltage is 240V.
3. The overload capacity indicated in % is the ratio of the overload current to the
inverter's rated output current. For repeated duty, allow time for the inverter
and motor to return to or below the temperatures under 100% load.
4. The output voltage provided cannot be more than twice the power supply
voltage.
5. The power supply capacity changes with the values of the power supply side
inverter impedances (including those of the input reactor and cables). Use the
power supply capacity larger than the indicated.
6. Load applied to the motor will reduce the output voltage about 10 to 15%.
When using a general-purpose motor, it must be used under reduced load.
7. The rated output current in the parentheses applies when low acoustic noise
operation is to be performed at the ambient temperature higher than 40°C with
the Pr. 72 (PWM frequency selection) value set to 2kHz or higher.
K-NA 0.1K
kW 0.1
HP 1/8
0.3
0.8
(Note 7)
(0.8)
150% 60 seconds 200% 0.5 seconds (inverse-time
(Note 3)
0.5
0.6 (1.32)
0.2K
0.2
1/4
0.6
1.5
(1.4)
characteristics)
Three phase, 200V to 230V 50Hz/60Hz
Single phase, 100V to 115V 50Hz/60Hz
Single phase, 90V to 132V 50Hz/60Hz
Within ±5%
0.9
Enclosed type (IP20)
Self-cooling
0.6 (1.32)
190
SPECIFICATIONS
0.4K 0.75K
0.4 0.75
1/2 1
1.2 2
3.0 5.0
(2.5) (4.1)
1.5 2.5
1.0 (2.2) 1.7 (3.75)