Download  Print this page

Connection To The Pu Connector - Mitsubishi Electric FR-E500 Instruction Manual

Fr-e500 series transistorized inverter.
Hide thumbs

Advertisement

2.2.4 Connection to the PU connector

( 1 ) When connecting the control panel or parameter unit using a cable
Use the option FR-CB2… or the following connector and commercially available cable:
<Connection cable>
y Connector : RJ45 connector
Example: 5-554720-3, Nippon AMP
y Cable
: Cable conforming to EIA568 (e.g. 10BASE-T cable)
Example: SGLPEV 0.5mm×4P, MITSUBISHI CABLE INDUSTRIES,
LTD.
<When using the control panel>
Note: The rear cover and junction adaptor are required since the circuit board is
exposed in the back of the control panel.
Use the FR-E5P option (cover and adaptor available as a set).
<Maximum wiring length>
y Control panel (FR-PA02-
y Parameter unit (FR-PU04): 20m (65.62 feet)
( 2 ) For RS-485 communication
The PU connector can be used for communication
operation from a personal computer etc.
When the PU connector is connected with a
personal,
FA
or
communication cable, a user program allows the
inverter to be run and monitored and the parameter
values to be read and written.
<PU connector pin-outs>
Viewed from the inverter (receptacle side) front
Note: 1. Do not connect the PU connector to a computer's LAN board, FAX modem
socket or telephone modular connector. Otherwise, the product may be
damaged due to electrical specification differences.
2. Pins 2) and 8) (P5S) provide power to the control panel or parameter unit.
Do not use these pins for RS-485 communication.
): 20m (65.62 feet)
02
other
computer
28
INSTALLATION AND WIRING
by
a
8) to 1)
1) SG
5) SDA
2) P5S
6) RDB
3) RDA
7) SG
4) SDB
8) P5S

Advertisement

Table of Contents

   Related Manuals for Mitsubishi Electric FR-E500

This manual is also suitable for:

Fr-e520Fr-e540Fr-e510w

Comments to this Manuals

Symbols: 0
Latest comments: