Mitsubishi Electric FR-E500 Instruction Manual page 175

(3)Read Pr. 903 and show the current setting of the gain frequency.
(Pr. 902, Pr. 904 and Pr. 905 can also be adjusted similarly.)
z
Parameter setting mode
Using the
MODE SET
STOP
FWD
RESET
SET
Most significant
digit flickers.
0 to 9
Current setting of gain frequency
(4)Set a new gain frequency in Pr. 903 and show the analog voltage monitor value
across terminals 2-5 (when the frequency is set to 80Hz)
Current setting of
gain frequency
key, choose the "parameter setting mode" as in (2)-1).
MODE
PU
REV
Middle digit
flickers.
×9
times
SET
Hz RUN
A
MON
PU
EXT
z
Changing the gain
frequency
Hz RUN
A MON
PU EXT
Press
the set frequency.
z
Monitoring the analog voltage (%)
across terminals 2-5
In any of the methods in (5) to (7) on the following pages,
continue the setting until the analog voltage monitor value
flickers. If you end the setting here, the gain frequency
change will not be reflected.
Least significant
digit flickers.
SET
0 to 9
Hz RUN
A MON
PU EXT
to change
Press for 1.5 sec.
SET
Hz RUN
A
MON
PU
EXT
160
PARAMETERS
×3
times
SET