Table of Contents
Advertisement
Quantum and Evolution Series Installation and Operating Handbook
SAF Screen
7.4.10 SNMP Configuration
It is possible to enable and configure the Simple Network Management Protocol (SNMP)
v1, v2c agent within the modem, through the web interface. SNMP is switched off by
default. An SNMP MIB is provided on the modem and can be downloaded from the
SNMP Configuration screen. The SNMP facilities of the modem are documented in the
'Remote M&C Specification for Quantum and Evolution Series Satellite Modems'. The
SNMP configuration screen (found under the Edit-Unit-M&C-Advanced menu tab) is
shown overleaf. The community names represent passwords that must be present in
each SNMP read or write requests in order for the commands to be executed. The source
identifier fields can be used to define which source IP addresses read/write requests will
be accepted from. The trap receiver fields are used to define the IP address of a trap
server to which trap notifications will be sent when modem alarms are triggered.
7-182
Advertisement
Table of Contents
