Table of Contents
Advertisement
Quantum and Evolution Series Installation and Operating Handbook
instead.
IP – Remote (Rem M&C)
This allows the serial M&C data, received via IP from the local Modem to be used at
the distant end serial ports. (Compared to IP – Remote mode, this setting changes
the direction of the driven lines from the distant end Modem to account for RS485
cabling differences). Uses TCP port 6703. This link is a serial extension for control
of distant end equipments. Please refer to following pinout definition table.
IP – Forward to Remote
Only available when IP over ESC has been selected. This takes advantage of the
local IP address and forwards M&C information directly to the remote Modem. Uses
TCP port 6703. This link is a serial extension for control of distant end equipments.
Factory
RS232
default:
The following diagrams show how the M&C interfaces may be configured using the
IP – Local, IP - Remote and IP - forwarding options to facilitate distant end M&C.
Please note, the first two options form a pipe to transfer messages to the distant end
equipments and if M&C of the Modems is necessary then an alternative provision
must be made. The third diagram is an alternative illustration of IP-Remote and can
be facilitated by IP over the main data channel / multimux etc.
7-137
Advertisement
Table of Contents
