Table of Contents
Advertisement
Quantum and Evolution Series Installation and Operating Handbook
are being generated by a non-Paradise modulator – a Paradise
modulator will always set the MPE MAC address to all zeros or the
modulator's MAC address, depending on whether it is in bridging or
routing mode.)
Edit-Unit-Interface-IP Cisco HDLC Screen
Cisco HDLC: [On]
Factory default:
Off
In routing mode, controls whether Cisco HDLC is used to
Description:
encapsulate IP packets being transmitted over satellite. This mode
can be used to receive and output the IP stream as a serial stream to
a Cisco serial router.
Edit-Unit-Interface-IP Encapsulation PID Screen
Encapsulation PID: 768 to 1023mins
New: 970
None
Units:
768
Minimum value:
1023
Maximum value:
1
Step size:
970
Factory default:
When encapsulating Ethernet frames or IP packets into MPEG2 packets,
Description:
this specifies the PID value to be entered into the MPEG2 packets that
are being created. Note that the value is in decimal. (The PID can then
be used for filtering MPEG2 packets on the receive side.)
1:Off
2:On
[970] Step 1
7-127
Advertisement
Table of Contents
