Table of Contents
Advertisement
Quantum and Evolution Series Installation and Operating Handbook
Edit-Tx-Interface-Number of Timeslots Screen (Quad E1 interface card)
None
Units:
0
Minimum value:
32
Maximum value:
1
Step size:
0
Factory default:
This sets the number of timeslots dropped off the terrestrial bearer and
Description:
sent over the satellite in relation to the specific terrestrial port of the
Quad E1 card.
Edit-Tx-Interface-Dropped Timeslots Screen (Quad E1 interface card)
Units:
0
Minimum value:
31
Maximum value:
1
Step size:
0
Factory default:
Controls which terrestrial timeslots are dropped (i.e. multiplexed into the
Description:
satellite frame). Timeslots cannot be reordered when being used with the
Quad E1 card. Timeslots can be entered as individual numbers
separated by commas or as an inclusive range denoted by the first and
last timeslot numbers in the range with a hyphen between them. For
example, '0,17,18-31'.
Note that on this screen the Down arrow key is used to enter a comma
and the Up arrow key is used to enter a hyphen. The 0 key pressed
together at the same time as the Right arrow key deletes the character at
the cursor.
Port 1 no. timeslots: 0 to 32
[0] Step 1
New: 0
Port 1 dropped timeslots
[0-2]
New: 0-2
7-78
Advertisement
Table of Contents
