Table of Contents
Advertisement
Quantum and Evolution Series Installation and Operating Handbook
Controls what language is used on all user interfaces. Note that this
Description:
causes the modem to reset in order for the change to take effect.
Edit-Unit-Advanced-1-for-N Screen
Options:
Address range 1 to 16
1
Minimum value:
16
Maximum value:
1
Step size:
Factory default:
None
Sets the 1:N address for the modem to communicate with a redundancy
Description:
switch. Note: the modems position within the redundancy switch system
dictates the 1:N address. Please see separate redundancy switch
operating manual.
Edit-Unit-Advanced-Adj Ref Screen
Only applicable on L-band modems.
This allows the frequency of the internal 10MHz reference to be adjusted by using the up
and down arrows. This can be adjusted off line by setting the modem to CW. Use a
calibrated spectrum analyser set to count mode, or frequency counter and adjust the
modem output for exactly 10MHz.
Edit-Unit-Advanced-1-for1 Screen
1:N address : 1 to 16
[01] Step 1
New : 01
Adjust 10MHz reference:
[080]
080
Receive fail switchover: [Off]
1:Off
2:On
7-155
Advertisement
Table of Contents
