Paradise Datacom Quantum Installation And Operating Handbook page 21

Quantum and Evolution Series Installation and Operating Handbook
Feature
Web acceleration
Sequential FEC
Wideband L-band
IP terrestrial
G.703 clock extension
LDPC FEC
LDPC FEC
LDPC FEC
LDPC FEC
Adaptive signal pre-
distorter
Dynamic routing
DVB-S2 Tx
DVB-S2 Rx
DVB IP
VCM (Quantum
modems only)
SAF Code
WEB Enables accelerated browsing using HTTP
(requires the modem to be fitted with a P3714 IP
traffic card).
SEQ Enables Sequential FEC up to a maximum of
2Mbps.
WRF Enables selection of additional L-band
frequencies between 1950MHz and 2050MHz.
IPT Enables IP Terrestrial base modem interface for
PD10 Modem
CLK When enabled provides a high stability G.703
(T1 or E1) timing reference to the distant end of
a satellite link.
LDPC5 Enables LDPC FEC scheme to a maximum
data rate of 5Mbps.
LDPC10 Enables LDPC FEC scheme to a maximum
data rate of 10Mbps.
LDPC25 Enables LDPC FEC scheme to a maximum
data rate of 25Mbps.
Enables LDPC FEC scheme to a maximum
LDPC55
data rate of 55Mbps (Evolution PD55) or
60Mbps (Quantum PD60).
ASP Allows 16QAM constellations to be adaptively
predistorted to counter the effects of nonlinear
distortion in the communications path. Requires
modem hardware above a certain revision
number – please contact Customer Technical
Support for details.
RTG Enables choice of RIP, OSPF and BGP dynamic
routing.
DVB2T Enables DVB-S2 Tx operation (includes
SmartLink).
DVB2R Enables DVB-S2 Rx operation (includes
SmartLink).
DVBIP Enables MPE, ULE and (Paradise proprietary)
PXE DVB over IP encapsulation (requires P3714
IP Traffic card). Quantum modems only.
VCM DVB-S2 Variable Coding and Modulation mode,
allowing each stream in point-to-multipoint IP with
a shared outbound carrier to use a different
modulation and FEC rate, specific to each remote
modem.
Software Activated Features (continued)
6-9
Description