Table of Contents
Advertisement
Quantum and Evolution Series Installation and Operating Handbook
Note that pressing 1 on the key pad while on this screen will inject an error and that
pressing 2 will restart the test.
Pressing the Down arrow key at any point displays the following screen.
Results:
The Inject error option can be used to inject a single error into the bit pattern, which has
the effect of incrementing the number of bit errors by one. Note that pressing 1 on the key
pad while on the results screen has the same effect.
The Restart test option is used to restart the BER test including clearing all of the error
counts. Note that pressing 2 on the key pad while on the results screen has the same
effect.
Pressing the Back key returns the display to the previous results screen.
Test-RF-CW Screen
Modulator CW: [Off]
Factory default:
Off
Selecting Tx CW causes a pure carrier to be transmitted rather than the
Description:
normal modulated carrier. This is useful for evaluating phase noise and
spurious but should not be used over a live satellite link without the
operator's permission.
Test-Modulator-RF-Alternate 1,0 Screen
Modulator alternate 1,0: [Off]
1:Inject error
2:Restart test
1:Off
2:On
1:Off
2:On
7-164
Advertisement
Table of Contents
