Arris Touchstone WTM552 User Manual page 46

Getting
Safety Started
Jump directly to one of the following topics:
• Configuration Basics
• Accessing the Configuration Interface
• Configuring System Settings
• Setting Up Your WAN Connection
• Setting the MAC Address
• Setting Up DNS
• Configuring the LAN Channel and Name
• Configuring Wireless Security
• Configuring the Firewall
— Configuring Virtual Servers
— Configuring Client IP Filters
— Configuring MAC Address Filtering
— Configuring the DMZ
• Configuring DDNS
• Configuring Wireless Bridging
Battery
Installation Installation
Wireless Ethernet
Configuration Configuration
Configuring Wireless Bridging
The Telephony Modem supports the Wireless Distribution System (WDS), a com-
mon bridging standard that allows you to extend the range of a wireless network
by connecting several wireless routers.
Keep the following in mind when setting up wireless bridging:
• One device (in this case, the Telephony Modem) acts as the router. Other
wireless routers must be configured as Access Points. See the documenta-
tion for your additional devices for instructions for using them as Access
Points.
• While the Telephony Modem has the ability to be configured as an Access
Point, doing so disables the router function and therefore disables Internet
access through the Telephony Modem.
• Each wireless router must support WDS.
• The Router and each Access Point must use the same channel number and
security settings.
• If MAC address filtering is enabled, the router and each Access Point must
have the MAC addresses of the other devices in their access lists.
Follow these steps to set up wireless bridging. The steps assume you have already
configured the devices as described above.
1 In the Telephony Modem, click the Wireless Setup link in the navigation
menu, then click Wireless Bridging.
The Wireless Bridging window appears.
2 Check the Enable Wireless Bridging box.
3 (recommended) If you want to specify which Access Points are allowed to
connect to your network, check the Enable ONLY Specific Access Points to
Connect box and enter the MAC address of each Access Point in the AP1
through AP4 fields. You can enter up to four Access Points.
Note: Most wireless devices have their MAC addresses printed on a label at-
tached to the back or bottom of the unit. Make sure you enter the wireless
(WLAN) MAC address; the Ethernet and WAN connections have different
MAC addresses.
4 Click the Save button to save your changes.
Touchstone® WTM552 Telephony Modem User's Guide
Usage Troubleshooting Glossary
46