Camera Mounting - FLIR D-Series C Installation Manual

1 D-Series C Camera Installation
1.6.3
The camera mount must nominally be rated to support at least 11.4 kg (25 lbs). For some
installations, the mount must support even greater weights. Use a mount which will provide adequate
support in adverse weather and environmental conditions. The D-Series C camera can be secured to
the mount two ways:
•
•
Refer to the ICD for additional information (FLIR Doc. # 427-9XXX-XX-19).
1
2
3
4
1-6

Camera Mounting

1.5" npt threaded coupler
Intended for rigid mounting with the supplied NPT stainless steel coupler, or equivalent.
Important: Use PTFE pipe seal tape or equivalent on the coupler.
M5 x 0.8 fasteners (quantity 6) 
If using four M5 x 0.8 fasteners, the maximum depth of the fastener should not exceed 10.0 mm
(0.4 in). Use Loctite 222 low strength threadlocker for the M5 fasteners.
Figure 1-1: D-Series C Camera Bottom Mounting Holes
M5 bolt circle diameter 66 mm (2.598 in)
6X M5 X 0.8 fasteners, equally spaced at 60°; maximum fastener engagement 10 mm (.394 in)
1-1/2 in NPT threaded opening
Do not loosen or remove the cable gland nut; doing so could result in damage to the camera unit
Table 1-2:
427-9030-01-12 Rev 130 Mar 2014