Location Considerations; Camera Mounting - FLIR A3 F series User Manual

Hide thumbs Also See for A3 F series:
Table of Contents

Advertisement

Calibration certificate
Downloads brochure
FLIR Sensor Manager CD-ROM
Lens cap
Printed Getting Started Guide
Printed Important Information Guide
Service & training brochure
Small accessories kit
User documentation CD-ROM
FLIR Tools & Utilities CD-ROM
Registration card
The installer will need to supply the following items; the lengths are specific to the
installation.
Electrical wire, for system power; up to 100' (3-conductor, shielded, gauge deter-
mined by cable length and supply voltage.
Camera grounding strap
Coaxial RG59U video cables (BNC connector at the camera end) for analog video
Shielded Category 6 Ethernet cable for control and streaming video over an IP
network; and also for software upgrades.
Optional serial cable for serial communications
Miscellaneous electrical hardware, connectors, and tools
8.3

Location considerations

The camera will require connections for power, communications (IP Ethernet, and/or
RS232/RS422}, and video.
NOTE: Install all cameras with an easily accessible Ethernet connection to support future software upgrades.
Ensure that cable distances do not exceed the Referenced Standard specifications
and adhere to all local and Industry Standards, Codes, and Best Practices.
8.4

Camera mounting

FLIR A3xx f series cameras must be mounted upright on top of the mounting surface,
with the base below the camera. The unit shall not be hung upside down.
The FLIR A3xx f series camera can be secured to the mount with three to five 1/4"-20
bolts or studs as shown below.
Once the mounting location has been selected, verify both sides of the mounting
surface are accessible.
Publ. No. T559743 Rev. a601 – ENGLISH (EN) – April 26, 2012
8 – Installation (FLIR A3xx f series)
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

A3 pt series

Table of Contents