Camera Link Module Accessory; Figure 11. Camera Link Module (Shown Installed On A Tau Swir Camera) - FLIR Tau SWIR User Manual

Camera Link Module Accessory

The Camera Link module is an expansion board for FLIR cameras that matches the functionality of the
VPC Module and adds the ability to access digital data via Camera Link connection. The Camera Link
module takes CMOS-type digital data from the camera and converts it to Camera Link. In order to use a
Camera Link module for acquisition of data, first enable the digital data output using the FLIR Camera
Controller GUI. The red/black wires connect to the TEC board. The black and green wires are connected
to the external synchronization signal in the camera. This accessory does not include a Camera Link
cable, frame grabber, or capture software.
Figure 10. Camera Link Module (shown installed on a Tau SWIR camera)
Page 19
The information contained in this document pertains to a dual use product controlled for export by the Export Administration
Regulations (EAR). Diversion contrary to US law is prohibited. US Department of Commerce authorization is not required prior to
export or transfer to foreign persons or parties unless otherwise prohibited.