FLIR D-Series Quick Connect Manual

Hide thumbs Also See for D-Series:

Download this manual See also: Operation & Installation Manual, Installation Manual

Installation Overview

The D-Series is shipped from the factory in one of two configurations, either dome

up or dome down, depending on the model ordered.

Confirm that the camera matches the intended installation.

All connections are made via the attached pigtail cable assembly.

• Ensure that all pigtail connections are made inside a water-tight enclosure.

Caution!

Before installing the D-Series camera be sure to read and understand the following

documents which provide details regarding mechanical dimensions and installation

safety. These documents are available on the CD or from the FLIR web site.

•

D-Series Installation Manual (FLIR Doc # 427-9030-01-12)

•

D-Series Interface Control Document (FLIR Doc # 427-9XXX-XX-19)

Do not disassemble the D-Series camera. Damage to the camera can occur as the

result of careless handling or electrostatic discharge (ESD).

Prior to making any connections, ensure the power is switched off.

427-9030-01-28 Rev 120

Quick Connect Guide

D-Series

March 2018

Page 1: Installation Overview
Quick Connect Guide D-Series Installation Overview The D-Series is shipped from the factory in one of two configurations, either dome up or dome down, depending on the model ordered. Confirm that the camera matches the intended installation. All connections are made via the attached pigtail cable assembly.
Page 2 The electrical connections are made with a short pigtail cable assembly which exits the base of the camera. The D-Series camera is both an analog and an IP camera. • Analog video will require a coax cable connection to a video monitor or an analog matrix/switch.