FLIR D-Series C Installation Manual page 27

2 Basic Operation and Configuration
Note
It is not possible to change the settings for Interface: eth1 with the web tool. Do not use an IP
address for the eth0 interface that is in the same network range as the eth1 IP address
(192.168.2.x). Contact FLIR Technical Support if it is necessary to use an address in that range for
the eth0 network interface.
When the LAN settings are changed and the Save button is clicked, a pop-up message will appear to
indicate the network interface should be restarted.
Once all the changes have been made and saved, scroll to the bottom of the page and click on the
Restart Network button.
If the Hostname is changed, the new name may not show up in FSM until the camera is rebooted. To
reboot the camera, save any configuration changes, then select Server Status and click the Reboot
button.
Note
The IP address is temporarily displayed on the video for a short while after the camera boots up. If
you are unsure what the camera IP address is set to, it may useful to reboot the camera and watch
for the IP Address information after the camera boots up.
To reset the IP address (and other configuration settings and login passwords) to the factory default,
refer to section 3.8 "Restoring the Factory Settings" on page 3-17.
427-9030-01-12 Rev130 Mar 2014 2-13