H3C SecPath F100-C Installation Manual page 46

Installation Manual
H3C SecPath F100-C Firewall
Set up the configuration environment as shown in Figure 4-1 and
boot the H3C SecPath F100-C. When the information "Press Ctrl-B to
enter Boot Menu" appears on the terminal screen, press <Ctrl+B>.
The system displays:
Please input Boot ROM password :
Caution:
To enter the Boot Menu, you must press <Ctrl+B> within three
seconds after the prompt "Press Ctrl-B to Enter Boot Menu...?"
appears. Otherwise, the system starts decompressing the program.
If you want to enter the Boot menu after the system starts
decompressing the program, you need to reboot the H3C SecPath
F100-C.
Input the correct password and press <Enter>. (If no Boot ROM
password is configured, just press <Enter>.) The system accesses the
Boot menu.
I. Boot menu of the H3C SecPath F100-C firewall
Boot Menu:
1:
2:
3:
4:
5:
6:
Download application program with XMODEM
Download application program with NET
Start up and ignore configuration
Enter debugging environment
Boot Rom Operation Menu
Do not check the version of the software
Chapter 5 Maintaining the H3C
5-2
SecPath F100-C