H3C SecPath F100-C Installation Manual page 29

Installation Manual
H3C SecPath F100-C Firewall
II. Recommended power socket
You are recommended to use a single-phase three-terminal
socket with an earth contact, which must be properly grounded. The
building ground system is often buried during the wiring engineering.
Make sure that the building ground system is normal before
connecting the AC power cord.
III. Connecting the AC power cord
Step 1: Check the power switch of the H3C SecPath F100-C is in
OFF position.
Step 2: Connect the output of the PSU to the input on the rear
panel of the H3C SecPath F100-C, and then insert the input connector
of the PSU into an AC power outlet.
Step 3: Push the power switch of the H3C SecPath F100-C in ON
position.
Step 4: Check that the PWR LED on the front panel of the H3C
SecPath F100-C is ON. If the LED is OFF, repeat steps 2 through 4.
Caution:
If the Power LED is still off after you repeat steps 2 through 4 several
times, refer to Chapter 6 "Troubleshooting".
Chapter 3 Installing the
3-6