Replacing A Fuse; Required Equipment; Procedure - Lucent Technologies PortMaster OR-HS Hardware Installation Manual

Replacing a Fuse

Replacing a Fuse
If the Office Router loses power while connected to an active power source, check the
fuse.
Follow these instructions to check and replace the fuse in the Office Router.

Required Equipment

• 5/32-inch flathead screwdriver
• 250V, 2A fuse

Procedure

1. Turn the power switch off and disconnect the Office Router from the
power source.
2. Detach the power cord from the Office Router.
3. Insert a 5/32-inch flathead screwdriver between the fuse door and the
chassis, and gently pull the fuse door open.
A-8
Ethernet
1186_0021
1186-0017
PortMaster Office Router Hardware Installation Guide
S1 - PC-Card S0
1186-0021