This appendix provides the following troubleshooting information for the
PortMaster Office Router:
•
Observing LED behavior
•
Observing the console display (OR-M)
•
Observing boot messages
•
Replacing a fuse
Observing LED Behavior
Table A-1 identifies LED behavior, likely causes of the behavior, and potential
solutions.
Table A-1
LED Indication
System LED does not light.
During startup, the System
LED fails to light, becomes
solidly lit, or blinks three times
per second continuously.
Troubleshooting
Hardware Problems and Solutions
Likely Cause
Power is not present.
There is a hardware problem.
Troubleshooting
Solution
Check the power switch,
power cable, outlet, and fuse.
For instructions on checking
and changing the fuse,
see "Replacing a Fuse" on page
A-8.
Contact Lucent Remote Access
Technical Support.
A
A-1