Procedure
Connect an ISDN BRI line to ISDN S/T or ISDN U port (OR-U shown).
If you are using an NT1 device with the S/T interface, connect the ISDN BRI line
to the NT1, and connect the NT1 to the ISDN S/T interface using the cable
supplied by Lucent.
7. Connect a PCMCIA Modem (OR-M)
Follow these instructions to connect a PCMCIA modem to the PCMCIA slot on the
OR-M.
Required Equipment
Type 2 PCMCIA modem card (See "PCMCIA Modems" on page E-1 for modem
information.)
Cable used to connect the modem card to a wall jack
This cable is usually supplied with the modem card.
Procedure
Note – Ensure that the PCMCIA modem is facing right side up when it is inserted.
Refer to the modem manufacturer's documentation for this information.
1. Insert the Type 2 PCMCIA modem into the PCMCIA modem slot.
Installing the PortMaster Office Router
ISDN/U
Ethernet
S1-S2
ISDN/U
S1-S2
Connect a PCMCIA Modem (OR-M)
S0
1186-0004
2-9