Turn On Power; Procedure - Lucent Technologies PortMaster OR-HS Hardware Installation Manual

Turn On Power

set pots—displays the setting (enabled/disabled) of the analog PHONE port.
set pots on—enables the analog PHONE port.
set pots off—disables the analog PHONE port.
show pots—displays the status of the analog PHONE port and the B channel
associated with it.
set u-law—enables North American (T1 areas) digital signal attenuation.
set a-law—enables International (E1 areas) digital signal attenuation.
9. Turn On Power
Follow these instructions to start the Office Router.

Procedure

1. Attach the power cord to the Office Router and to a properly grounded
electrical outlet (OR-M shown).
2. Turn the power switch on (OR-M shown).
3. Verify that the System LED is active (OR-M shown).
2-12
Ethernet
1186_0012
Ethernet
1186_0011
PortMaster Office Router Hardware Installation Guide
S1 - PC-Card S0
1186-0012
S1 - PC-Card S0
1186-0011